UN-CUREâ„¢ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CUREâ„¢ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option. We have used this product on slot car chassis to remove magnets and glued in bushings and have not had any problem with it softening the plastic. We do recommend that you test it first.